Industrial Tools

3000 G - Working at height Heavy Duty Engineer

Code 44392011

Tramontina PRO line of tools and accessories for working at height is in accordance with the requirements of specific standards for this segment. These standards are mandatory, with national validity, and were created thinking about the security and health during all activities in industry, construction companies, or general service companies, where a fall risk is present. An activity is considered a working at height activity when it is performed over two meters from the ground. For tools, these regulation standards act on the accidents prevention generated from the tools falling, which must be prevented through the use of special procedures such as: tool tying, net usage, or any other method that avoids this potential risk. To avoid lowering others? opinions, use the Tramontina PRO tools at height system.

SUPPORT MATERIALS:
  • Folheto Folheto

Product features

Main Functions and Benefits Forged chrome molybdenum steel head.
Hardened carbon steel tube handle.
Hardening on the striking faces.
Polished and varnished bases.
Injected handle grip.
Head fixed by elastic pin.
ASME B107.54.
DIN 6475.
Heat shrink connector.
Suitable for heavy duty jobs in reduced working areas.
Forged and hardened head in special alloy steel, avoiding chips and cracks during heavy duty jobs.
Carbon steel tube handle head fixed by elastic pin guarantees the maximum safety for the user and eliminates the risk of head detachment.
The special shorter handle is designed to allow jobs in confined working areas.
Ergonomic grip, providing more comfort and adherence to the hand.
Handle length is not standard.
Suitable for working at height jobs.
Recommendations for Use Wear safety glasses, gloves and others safety equipments according to the job.
Never use a hammer with excessive wear, loose or damaged handle, burr or cracks on the head. Hammers with these problems must be replaced.
Never make any changes to the product like welding on the head or changing its handle.
Never strike two hammers, one against the other.
Always use the impact face for hit. Never strike anything with the sides of the hammer, as the hardening is just located on the impact faces. - Always observe the recommended use for each kind of hammer before use.
Always strike the hammer perpendicularly to the surface or work tool. It avoids the premature distortion of the impact face, as well as chipping.
Select the hammer that will hit the chisel or pin as follows: The impact face shall have a diameter 10 mm bigger than the face to hit.
Store in clean and dry place.
Weight 3,70 kg
Dimensões
  • A: 60.0 mm
  • B: 57.0 mm
  • C: 140.0 mm
  • D: 500.0 mm