Tramontina PRO line of tools and accessories for working at height is in accordance with the requirements of specific standards for this segment. These standards are mandatory, with national validity, and were created thinking about the security and health during all activities in industry, construction companies, or general service companies, where a fall risk is present. An activity is considered a working at height activity when it is performed over two meters from the ground. For tools, these regulation standards act on the accidents prevention generated from the tools falling, which must be prevented through the use of special procedures such as: tool tying, net usage, or any other method that avoids this potential risk. To avoid lowering others? opinions, use the Tramontina PRO tools at height system.
|Main Functions and Benefits||Forged chrome vanadium steel.
Full hardening at the body.
Polished head and joint.
Induction hardening at the cutting edge.
Electrical insulation up to 1.000V AC.
Heat shrink connector with plastic swivel ring.
Used to pull, fasten, roll, bend and cut wires and thin metal sheets.
Suitable for working at height jobs.
|Recommendations for Use||
Always wear safety glasses to protect the eyes.
Wear gloves to protect the hands.
Never use pliers as a hammer. It can crack or even break.
Never expose pliers to excessive heat. It can change the heat treatment applied at the cutting edges and reduce the performance of the pliers.
Always ensure pliers are perpendicular to the wire for a quicker and safer operation.
The grip on most pliers is provided for comfort only. Pliers that can be used on electrical lines, are identified on the grip with the marking 1000V. You must ensure that you inspect the electrical insulation on a regular basis. If the insulated grip becomes cracked, you must stop using the pliers immediately.
Oil the joint occasionally as this will extend the life of the pliers and improve their use.
Never increase the length of the plier handle. It increases the load applied on the plier head and can break it.
Always use the correct type of pliers for the job. Never use pliers to cut hardened wires, unless they are designed for this purpose.
Never use the pliers on nuts or screws. A wrench or spanner makes a better job and reduces the risk of damaging the edges.
Store the pliers in a clean and dry place.
Keep pliers out of the reach of children.
* You can compare up to 4 products per category.
Com a Tramontina, você sempre conta com a melhor solução para seu negócio. Preencha o formulário e solicite seu orçamento.
TRAMONTINA PRO MODULAR STORAGE SYSTEMS: TAILOR MADE FURNITURE FOR MECHANICAL WORKSHOPS.
E-mail: [email protected]
Horário: 7:15 às 12:00 e das 13:00 às 17:00.